Can pitted motorcycle forks be repaired?
Our pitted forks and fork stanchion repair services are specifically designed to restore your rusty, scored or scratched fork stanchions back to better than new! All forks are checked for straightness prior to the fork stanchion repair.
Are pitted motorcycle forks an MOT failure?
Not only are damaged and underperforming forks dangerous on the road, they are also an MOT failure. The conditions of the MOT test require that: There should be no oil visible on the fork tube or leaking down the slider around the fork oil seal areas. The forks must be adequately dampened.
What causes fork pitting?
The primary reason fork seals can fail is pitted forks. Forks naturally become pitted over time. Rocks fly up and hit the forks. If they’re not totally covered, they can cause small scratches.
Can you sand motorcycle forks?
you should sand them with 2000 grit sandpaper. The point was that the manufacturers only go so far to polish them and they can be a lot smoother, thereby helping fork seals to resist wear. Any roughness would be annular and the seals move longitudinally.
How do you clean fork tubes?
Step 1: Wipe the fork tube down with contact cleaner and a rag to remove debris from the surface. Step 2: Use a flat head screw driver to pull the seal scraper down. (The seal scraper is the first line of defense for the actual seal).
How do you clean pitted aluminum forks?
Cornstarch can be purchased at any supermarket. Dip the clean towel into the box and wipe the wheel thoroughly with the cornstarch. The cornstarch will absorb the excess polish from the pores of the aluminum and eliminate any streaks in the finish. To remove any cornstarch powder, use compressed air. “
How do you fix a fork pitting?
Use the more coarse wet and dry sandpaper, with plenty of water, to smooth over all the pits you want to treat. I used #400 but for a better looking job, start with #600. (Note: You don’t have to treat pits that are higher up the tube than where the sliders and seals will reach.
Can you polish motorcycle forks?
Since most motorcycle fork tubes are made from aluminum, they can be polished to a near chrome-like shine using only a few easily obtained items. However, while polishing your fork tubes yourself can save you a great deal of money, the project takes patience and determination.
What do you clean fork tubes with?
How do you remove corrosion from motorcycle forks?
How to remove rust from your bike’s chrome
- Give the area a good wash with soapy water.
- Rub the area down with aluminium kitchen foil and a bit of water.
- Rub gently.
- Rinse, clean, and repeat the foil stage on any stubborn bits of pitting.