How do you fix the code on a hot tub?
How to Troubleshoot a Hot Tub FLO Error Code
- Shut down the spa at the breaker.
- Make sure there is no debris in the water that can get sucked into the pump.
- Take out all of the filter(s) and set them aside.
- Turn spa back on at the breaker with the filters out.
What does Error Code EC mean on hot tub?
Economy Heating Mode
If the Ecn or Ec Message is ON Solid (Not Flashing) on the Display, the Spa is Operating in the Economy Heating Mode, but there is No current water temperature because the Spa is between Filter Cycles. Ecn or Ec is Alternating with Temp: The Spa is Operating in the “Economy” (Ecn or Ec) Heating Mode.
What does code SL mean on hot tub?
Sleep –
SL: Sleep – Sleep mode will only allow the spa to heat within 20 degrees of the set temperature.
What is Dr code on hot tub?
A message such as “dr” or “dry” or “heater dry” is a warning that there’s no water in the heater tube, says Niagara Hot Tubs. Although safety sensors are supposed to detect a dry condition and shut off the heater, be sure to manually disconnect power to the pump and heater before troubleshooting the unit.
Where is the reset button on my hot tub?
Locate the spa’s high-limit reset. This is a red button found on many spa packs. It may be located on the heater and covered by a rubber nipple.
What does ECN mean on hot tub?
Ecn or Ec is Alternating with Temp: The Spa is Operating in the “Economy” (Ecn or Ec) Heating Mode. The Water Temperature is sampled Only during Programmed Filter Cycles. The Heater will only operate and Heat up to Set Temperature during the Filter Cycles.
What does 5l mean on a hot tub?
4, 04. Water sensor/pressure switch fault. 5, 05. Temperature sensor error, or water is dangerously hot.
How do I fix error code E02?
Please follow these steps to resolve this:
- Remove the spa pump from the liner, with the stopper caps placed on the inside.
- Empty the spa fully of water.
- Remove the stopper caps and place a hose on the inside of the spa, up against the debris screen.
- Complete this for 5 minutes on each debris screen.
How do you fix a flow error?
Switch off the power and remove the filters. After 20 minutes, switch the power back on and run the spa/jets without the filters to see if it clears the flow issue. If the flow clears, switch off the power again, replace the filter and then switch on the power.
What are some of the error codes for the spa?
Spa operating in Standard-in-Economy Mode. Gecko Spa Side Error Codes FLO Pressure switch failure, switch open FLC Pressure switch failure, switch closed Prr Temp sensor failure Prh Hi-limit sensor failure HL Sensor measuring 119 degrees FrE Possible freeze condition detected Hurricane Spa Side Error Codes PS Flow or pressure switch failure SH
What are the side error codes for the gecko spa?
Safety Suction, Spa is shut down. SE Spa operating in Standard-in-Economy Mode. Gecko Spa Side Error Codes FLO Pressure switch failure, switch open FLC
What do I do if my Master Spa is not working?
Below is a list of Master Spa error codes. The code on Master Spa is normally an easy fix, however, if your Master Spa code is not listed, please call customer care 855-308-2149; we do offer limited technical support. No message on display. Power has been cut off to the spa. Check your breaker and turn back on, if off.
How do I know what type of control system my spa has?
You can often determine the make of the control system by looking inside the spa’s equipment area. Disclaimer: Although we hope this information will be useful, error codes are subject to change without notice.