How does Cv relate to flow?
Valve Flow Coefficient (Cv) is the flow capability of a control valve at fully open conditions relative to the pressure drop across the valve. It is defined as the volume of water (GPM in the US) at 60°F that will flow through a fully open valve with a pressure differential of 1 psi across the valve.
How do you use Cv flow coefficient?
Find the pressure drop opposite your corrected Cv factor, then multiply this times the square of the flow of 1 GPM. Find the pressure drop at a flow of 16 GPM at the same Cv = 2.20. For values of Cv not listed in the table, use this formula for a flow of 1 GPM.
Is Cv proportional to flow?
Flow is proportional to the value of Cv. For example, a Cv of 150 would then equate to 150 gpm of water at 60′ F with a differential pressure of one psi.
How do you calculate flow factor?
Flow Calculation – (Kv)
- Kv = m3/h – Flow coefficient.
- Q = m3/h – Flow.
- Qn = m3n/h – Normal flow (20°C 760mm Hg)
- P1 = bar – Inlet pressure – (Gauge pressure + 1)
- P2 = bar – Outlet pressure – (Gauge pressure – 1)
- DP = bar – Pressure drop – (Differential pressure between inlet and outlet pressure)
What is the Cv value?
What is Cv value? The valve flow coefficient according to the JIS standard, represents the flow capacity in US gallons/minute of 60° F pure water when it is flowing through the valve with a pressure difference of 1 psi at the specified travel (operation range).
What is Cv gas flow?
Valve Flow Coefficient (Cv) is a valve’s capacity for a liquid or gas to flow through it. It is technically defined as “the volume of water at 60°F (in US gallons) that will flow through a valve per minute with a pressure drop of 1 psi across the valve.”
How do you calculate water flow in a pipe?
If the liquid is flowing through a pipe, the area is A = πr2, where r is the radius of the pipe. For a rectangle, the area is A = wh where w is the width, and h is the height. The flow rate can be measured in meters cubed per second (m3/s), or in liters per second (L/s).
Is KV same as Cv?
Flow factor (Kv) is the metric system equivalent of the flow coefficient (Cv). Also referred to as International System of units (abbreviated as SI system). It is defined as the flow of water in cubic meters per hour (m³/hr) at a pressure drop of one bar with temperature ranging from 5 to 30 degree C.