What are D-rings on jeeps for?
D-Rings attach to anchor points on a Jeep, usually on the front or rear bumper, and are used for securing tow straps to pull a stuck vehicle to safety. Most Jeep D-Rings are 3/4″, but some can be run 1/2″, 5/8″, or 7/8″ depending on the mount.
What size shackles for Jeep?
D-Ring Shackles are a key piece of recovery equipment that everyone should have in their Jeep when you’re heading off road. Quadratec has both 5/8″ and 3/4″ shackles as well as d-ring isolators and 2″ hitch receiver mounts.
Can you weld ad shackle?
Shackle mounts are made of steel because steel is stronger than aluminum and it’s easy to weld to steel bumpers.
Are hitch shackles safe?
Shackle hitches provide a safer, reliable method of recovering a vehicle. What makes it so safe and reliable? For starters, the hitch receiver that the shackle block would plug into is bolted onto the frame. You also do not run the risk of the tow strap coming off like you would with a ball hitch.
What is a shackle pin?
A shackle, also known as a gyve, is a U-shaped piece of metal secured with a clevis pin or bolt across the opening, or a hinged metal loop secured with a quick-release locking pin mechanism. The term also applies to handcuffs and other similarly conceived restraint devices that function in a similar manner.
Can you use a weld on shackle mount on a JK?
If you need a heavy duty weld-on shackle mount, this is it. The EVO mounts bolt on to Jeep JKs, but can still be used on other 4x4s. If you need an even beefier Jeep JK Wrangler D-ring shackle mount, these are fully made of 3/4″ thick steel!
Do I need A D-ring or a shackle Mount?
If the answer is “No”, then you need to use a bolt-on D-ring mount. Here’s the deal: D-ring shackle mounts are thick and bumpers are thin (relatively).
What are the dimensions of a shackle Mount?
This mount is 1″ thick, 2″ high, and 4.5″ long overall. The shackle mount hole is 1″ bore – between that and the ability to through weld it on a bumper, this can be made into a very strong recovery point. These mounts are sold individually. Trail-Gear’s shackle mounts come either coped or flat and are made from 1020 cold-rolled steel.
How thick is the D-ring mount on a Jeep Wrangler?
If you need an even beefier Jeep JK Wrangler D-ring shackle mount, these are fully made of 3/4″ thick steel! Yup, both the back plate and the shackle pin plate are 3/4″ thick, which makes this the mount set with the thickest back plates.