What are the torque specs for Harley primary cover?
Registered. Outer primary cover is 108-120 inch (9-10 ft.) lbs. Derby is 84-108 inch (7-9 ft.)
What size are Harley primary cover bolts?
1/4″ x 20 thread, various lengths and head styles.
How much primary oil goes in a Harley Softail?
one quart
Fill the primary with oil Harley Davidson Softails require one quart of primary fluid.
What is a Harley Davidson Derby Cover?
A derby cover is a metal plate, usually made out of sheet steel, used to cover the clutch of motorcycles. Its main utility is to protect the workings of the clutch from possibly harmful dust and other possible contaminates.
What is the primary cover?
Primary Cover — the policy that responds first to an insured loss, either on a first dollar basis or after allowing for a deductible. When the primary coverage limits are paid, any remaining loss is covered by whatever excess layer of insurance may be in place.
What is a Harley derby cover?
How often should you change primary oil in my Harley?
How often should I change the tranny oil in my Harley? According to the manufacturer’s service manual, you should change the engine oil at 5,000 miles. Primary oil should change at 10,000 miles, and trans fluid at 20,000 miles. A transmission oil change should happen every year.
Why is it called a derby cover?
Derby hats were named after that peculiar shaped cover sometimes used on horses as early as medievil times. First worn by British knights, the derby cover prevented loss of oil from their horses and stopped saddle burnout or lance slippage dependant on amps. The original derby covers were made from turnips and stuff.
Is it a derby cover or a clutch cover?
How does a motorcycle primary work?
The primary drive consists of an engine output sprocket (attached to the crankshaft), clutch assembly, roller chain (or belt) and usually a housing that encloses the entire assembly. The purpose of the clutch is to engage the primary drive to the transmission.
What are the torque specs for the primary cover bolts?
You need a manual, as you need torque specs for the entire assembly of the primary cover, inner primary bolts, clutch hub nut, compensator, starter bolts, starter jackshaft bolt, swingarm pivot bolts and rear axle nut. 1.) Primary cover bolts: 14-21 ft lbs
What are the torque specs for the clutch bolts?
torque specs. 1.) Primary cover bolts: 14-21 ft lbs. 2.) Inner primary bolts: 18-24 ft lbs. 3.) clutch hub: (left hand thread) 55-60 ft lbs. 4.) compensator: 150-165 ft lbs. 5.) starter bolts: 24-28 ft lbs.
Is there a torque spec for the rear Cam?
Its also not a torque spec, rather a tolerance spec related to/for gear lash, as the drive gear I’d mounted to the crank and runs the rear cam. In addition to what has been said about torque specs.