What is default IP address cisco sg300?
192.168.1.254
By default, the address of the switch is set to 192.168. 1.254, and the username and password are both “cisco”. In the above case, you should set the IP address of the PC beforehand to 192.168. 1.
How do I access cisco sg300?
Open a browser and type 192.168. 1.254 in the address bar, username: “cisco” password: “cisco”, Click on the Log in button . After the login prompt, you will be asked to change that default password to whatever you want.
How do I reset my SG300 to factory settings?
Press and hold the Reset button on the switch for atleast 20 seconds until all the port LEDs light up. The switch will reboot now.
How do I reset my cisco SG300 password?
Console in and power cycle the switch, you should see the Cisco logo, then you have about two seconds to hit a key to get the boot menu. If you miss it (or it times out once your in it) just power cycle the switch again to bring it up again. On the switch in front of me it is option 3 to reset the password.
How do I reset my sg300 switch?
How do I reset my cisco SG300 28 switch?
First Method – Manual Reset
- Disconnect all the Ethernet cables from the Cisco sg300 switch.
- Press and hold the Reset button on the switch for atleast 20 seconds until all the port LEDs light up. The switch will reboot now.
- Connect your PC directly to the switch using an Ethernet cable.
What is the IP default gateway?
A default gateway is the node in a computer network using the Internet protocol suite that serves as the forwarding host (router) to other networks when no other route specification matches the destination IP address of a packet.
How do I reset my SG300 switch?
How do I reset my SG 350 switch?
Using a pin, press and hold the Reset button on the switch for 15 to 20 seconds. Step 3. Once all the port Light-Emitting Diodes (LEDs) light up, release the Reset button. In this example, SG350X-24 24-Port Gigabit Stackable Managed Switch is used.
https://www.youtube.com/watch?v=T5pqe9D9QjA