What is HC-06 Bluetooth?
The HC-06 is a class 2 slave Bluetooth module designed for transparent wireless serial communication. Once it is paired to a master Bluetooth device such as PC, smart phones and tablet, its operation becomes transparent to the user. All data received through the serial input is immediately transmitted over the air.
What is range of HC-06 Bluetooth?
HC-06 is a Bluetooth module designed for establishing short range wireless data communication (<100 meters). It is very easy to interface and communicate.
Is hc06 a ble?
HC-06 or HC-05 bluetooth module does not support BLE(Bluetooth Low Energy) communication.
What is HC-06 write about is feature?
HC-06 uses frequency hopping spread spectrum technique (FHSS) to avoid interference with other devices and to have full duplex transmission. The device works on the frequency range from 2.402 GHz to 2.480GHz.
What is the difference between HC 05 and HC-06?
Hc-05 is a Bluetooth serial port module with master-slave integration. The master-slave can be switched with rich and complete instructions. Hc-06 is a Bluetooth serial port module with master-slave integration. The master-slave can be switched by command, and the command is less than the-05, so it is easy to use.
What is HC-06 module?
The HC-06 bluetooth module is a slave bluetooth module designed for wireless serial communication. It is a slave module meaning that it can receive serial data when serial data is sent out from a master bluetooth device(device able to send serial data through the air: smart phones, PC).
What is hco6?
Introduction. The HC-06 bluetooth module is a slave bluetooth module designed for wireless serial communication. It is a slave module meaning that it can receive serial data when serial data is sent out from a master bluetooth device(device able to send serial data through the air: smart phones, PC).
What is the range of HC-05 Bluetooth module?
10 meters
It uses the 2.45GHz frequency band. The transfer rate of the data can vary up to 1Mbps and is in range of 10 meters. The HC-05 module can be operated within 4-6V of power supply. It supports baud rate of 9600, 19200, 38400, 57600, etc.
How do I put my HC-06 in mode?
For HC06: On arduino serial monitor type “AT” (without the quotes) and press enter, “OK” will confirm AT mode. Unlike HC05, you can’t see the default name or baud rate. You can only change them. To change name type AT+NAMEDESIRED NAME, notice that there should be no space between the command and name.
How do I connect the hc-06 Bluetooth module to my Device?
There are multiple versions of the module floating around, with different firmware and breakout boards, but the general functionality should match the HC-06 Bluetooth module datasheet. Connect the HC-06 Ground (GND) pin to ground (duh!). Connect the HC-06 VCC pin to 5v.
What is the difference between hc-05 and hc-06 Bluetooth modules?
Unlike the HC-05 Bluetooth module, this module can only act as a slave device. You will only be needing the four pins in the HC-06 Bluetooth module. RXD: Serial Data Receive Pin.
What can I do with the hc-06?
The HC-06 acts as a serial port through which you can send and receive data. So using a serial terminal or a Bluetooth customized application on your computer or phone, you can control and monitor your project.
How do I pair the ho6 with my device using Bluetooth®?
Begin pairing: To enter pairing mode on HO6, press and hold the top and bottom buttons until the LED starts flashing. The H06 will now show up as AIAIAl TMA-2 (HO6) in the available devices list on your device’s Bluetooth® settings page. Exit paring: To exit pairing mode, simply power off the HO6.